ADCMT 7351A - Relationship According to Disabling the Function

7351 Series Digital Multimeter Operation Manual
5.12.3 Disabling Functions
5-36
• Canceling the setting
To cancel the disabling setting and enable all functions, initialize in in or re-set
all functions in ‘F.Inhi’ in in .
Table 5-4 Relationship according to Disabling the Function
Setting function
Function depending on the function setting
Diode
ACV
(AC+DC)
ACI
(AC+DC)
Continuity ACI FREQ
DCV
ACV
DCI
ACI
2W/LP-2W
FREQ
: Automatically set to ENA or DIS according to a setting function.
: Disabled if any setting functions are set to DIS, and enabled if all setting functions are set to
ENA.
: Disabled if any of setting functions is set to DIS, and not enabled even if all setting functions
are set to ENA.
6 INIT
MENU
9 SYS
MENU