7351 Series Digital Multimeter Operation Manual
6.3.2 RS-232 Setting
6-7
CAUTION: This instrument cannot use the flow control performed by the X parameter (XON/XOFF).
6.3.2 RS-232 Setting
Header of output data
1. Select the following from 'HEADR' of in .
2. Press to apply the setting.
Talk-Only setting
1. Select the following from 'T.ONLY' of in .
ON: Talk-Only
OFF: Addressable
2. Press to apply the setting.
Baud rate
1. Select the following from 'BAUD' of in .
9600 - 300 - 600 - 1200 - 2400 - 4800
2. Press to apply the setting.
Number of data bits
1. Select the following from 'DATA' of in .
8 bit/7 bit
2. Press to apply the setting.
Parity
1. Select the following from 'P-Bit' of in .
NONE - ODD - EVEN
2. Press to apply the setting.
To Next Page
Loading...
