ADCMT 7351A User Manual

7351 Series Digital Multimeter Operation Manual
6.7.3 ADC Command Reference
6-30
System
Self-Test
*TST? Performs the self- test and reads the result.
(It takes time to perform the self-test. Read the result after
the self-test is complete.)
Reply 0 : Pass
1 : Fail
*8
Calibration
CAL0 Sets the calibration mode to OFF.
(Writes the calibration factor when leaving the calibration
mode.)
CAL1 Sets the calibration mode to ON.
CAL? Reply: CAL0 or CAL1
-
XOUT Cancels (sets to OFF) the calibration mode.
(Does not write the calibration factor.)
-
PCn Enters the STD value. (Displayed count value)
n:0 to 999999
XDTn Enters the STD value. (Displayed value)
n: Displayed value on STD
-
CMNT
"str"
Sets the calibration information.
Enclose the character strings by using (") or (').
Up to 50 characters (one byte alphanumeric characters) can
be stored.
-
CMNT?
Reply: CMNT"xxxx xxx"
-
Setting parameter
*SAVn n:0 to 3
Saves the setting parameters in area [n] of the non-volatile
memory.
-
SINI Sets the values when shipping to all area from [0] to [3].
-
*RCLn n:0 to 3
Loads the setting parameters from area [n] of the non-volatile
memory.
-
RINI Loads the values when shipping as the setting parameters.
-
Error log reading
ERR? Reads the error details.
Reply: ddd,"xxxxxxxxxx"
• Up to 20 error queues can be stored. The error is output
according to the FIFO system.
• If more than 20 errors occur, the last error is replaced with
-350, “Queue overflow”. Any errors after this are not
saved.
• If no error occurs, +000, “No error” is returned.
-
*8: Self-test items differ.
Item Command Description
Initial
value
R6451
Up to 50 characters
Error character strings
(Up to 80 characters)
Error code

ADCMT 7351A Specifications

General

Brand	ADCMT
Model	7351A
Category	Multimeter
Language	English