Adtech iMASTER – A1 Series - Page 129

A1-User’s Manual
１２５
 23.04 Acceleration time 1
Range: 0.1 ~ 3000 Sec in 0.1 Sec
Initial value: 30.0 Sec
 '23.03' (Ramp set selection) is 0
Always on
 '23.03' (Ramp set selection) is 1
Always off
 '23.03' (Ramp set selection) is 2
It not works if the output frequency is above
'23.10' (Acceleration time transition frequency)
 '23.03' (Ramp set selection) is 3~9
It works by digital input which is selected
 Related Parameters: '23.06' ,'23.07', '23.10', '23.11'
 23.05 Deceleration time 1
Range: 0.1 ~ 3000 Sec in 0.1 Sec
Initial value: 30.0 Sec
 '23.03' (Ramp set selection) is 0
Always on
 '23.03' (Ramp set selection) is 1
Always off
 '23.03' (Ramp set selection) is 2
It not works if the output frequency is above
'23.11' (Deceleration time transition frequency)
 '23.03' (Ramp set selection) is 3~9
It works by digital input which is selected
 Related Parameters: '23.06' ,'23.07', '23.10', '23.11'
 23.06 Acceleration time 2
Range: 0.1 ~ 3000 Sec in 0.1 Sec
Initial value: 30.0 Sec
 23.03' (Ramp set selection) is 0
Always off
 '23.03' (Ramp set selection) is 1
Always on
 '23.03' (Ramp set selection) is 2
It not works if the output frequency is below
'23.10' (Acceleration time transition frequency)
 '23.03' (Ramp set selection) is 3~9
It works by digital input which is selected
 Related Parameters: '23.06' ,'23.07', '23.10', '23.11'