AESFill AF1C Machine Manual 10/58 General Description
2. Installation
Unpacking the Machine 2.1
The machine is packed in a single crate or box. Small accessories will be packed in separate cartons and included in the main
machine crate. Large accessories, such as a feed tank stand, etc., would be packed in separate crates.
Remove the top and sides of the crate. Place all small packages in a safe area. Carefully remove the main body of the
AESFill AF1.
Carefully inspect the machine for any damage during transport, and if found, notify the carrier immediately.
Installing the Machine 2.2
2.2.1 Front of AESFill AF1
The AESFill Body consists of one stainless steel encased unit. This body houses the drive of the AESFill AF1, which is an AC Inverter
system with an exclusive frequency speed control. The machine is supplied to match your voltage but is convertible from 110/60/1
to 220/50–60/1. At this stage, please check the rating plate to see if it correctly matches your supply voltage.
The cabinet consists of the touch screen, the nozzle bar clamp
and the carry handle.
Figure 2-1: Rating Plate—Example
2.2.2 Rear of AESFill AF1
The AF1 is equipped with the below marked items on the rear
of the machine.
1. Exhaust Muffler so that the nozzles close smoothly.
2. Black and blue air hose connectors that connect to the
nozzle with 6 mm hosing.
3. Rating Plate with the AF1 serial number and other
specifications.
4. Air regulator that clean dry air should be attached with a
minimum of 60PSI.
To Next Page