Agilent Technologies 1260 Infinity User Manual

1260 Infinity Binary Pump User Manual 47
Installing the Pump
3
Installing the Binary Pump
4 Connect the required interface cables to the rear of the module.
Figure 15 Rear of the Binary Pump
5 Connect the capillary, solvent tubes and waste tubings (see “Flow
Connections with Solvent Selection Valve” on page 48 or “Flow
Connections without Solvent Selection Valve” on page 51).
6 Press the power switch to turn on the module.
7 Purge the pump (see “Initial Priming” on page 54).
The pump is shipped with default configuration settings. To change
these settings, refer to “Setting the 8- bit Configuration Switch (without
On- board) LAN” on page 228.
Configuration switch
Slot for interface board
RS232
Remote
Analog output
CAN-Bus
Power plug
HP-IB
NOTE
The power switch stays pressed in and a green indicator lamp in the power switch is on
when the module is turned on. When the line power switch stands out and the green light
is off, the module is turned off.

Agilent Technologies 1260 Infinity Specifications

General

Brand	Agilent Technologies
Model	1260 Infinity
Category	Laboratory Equipment
Language	English