Table of Contents
The Basics 1
To turn on the analyzer — AC power 2
To turn on the analyzer — DC Power 3
Todisplayhelpforakey 4
To preset the analyzer 5
To activate the input channels 6
To activate the input channels—Option AY6 7
To select an instrument mode 8
To type a text string 9
To change a numeric parameter 10
To move the main marker 11
To measure a value relative to a reference 12
Setting Up 13
To set the analyzer’s GPIB address 14
To set the analyzer’sclock 15
To select the default disk 16
Working with the Display 17
To select the active trace 18
To display traces 19
To select measurement data 20
To scale measurement data 22
To display the measurement state 23
To change parameters using the measurement state 24
To display a waterfall 25
To Next Page
Loading...
Need help?
General
