12 Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
1 Fast Installation
Installing Preconfigured Agilent Cary 8454 UV-Visible Systems
Installing Preconfigured Agilent Cary 8454 UV-Visible Systems
If you have purchased one of these systems, the software is pre- installed
and preconfigured. You need only install and switch on the hardware.
✔ Ensure you have space and an appropriate power supply.
For more information, see “Site Requirements for Your
Spectrophotometer” on page 19.
✔ Unpack the system—check for damage and contents against packing list.
For more information, see “Unpacking Your Spectrophotometer” on
page 22.
✔ Install your UV-Visible spectrophotometer.
• Connect line power to the rear.
• Connect the waste tubing underneath the sample pan.
For more information, see “Installing your UV-Visible
Spectrophotometer” on page 23.
✔ Install your computer and printer.
• Connect the keyboard and mouse.
• Connect the monitor to line power and to the computer.
• Connect the printer to line power and to the computer.
• Connect the computer to the spectrophotometer with the GPIB or
LAN cable.
For more information, see “Installing Your Computer” on page 29 and
Chapter 7, “LAN Communication, Installation, Connection and
Configuration”.
✔ Switch on the spectrophotometer (make sure the sample area is clear),
wait 2 minutes for the lamps to ignite. When you are ready to operate
your spectrophotometer, switch on the computer and printer.
For more information, see “Starting the Spectrophotometer” on page 31.
To Next Page
Loading...
Need help?
General
