Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide 107
GPIB Communication, Connections and Configuration 6
Troubleshooting
Problems with Plug and Play option GPIB cards
Operation systems using Plug and Play may show problems during the
installation of the appropriate drivers for the GPIB (PCI) cards.
In order to overcome plug and play related problems please follow the
steps to install the card successfully.
1 If already installed, un- install the Agilent IO Libraries from Control
Panel, Add/Remove Programs.
2 Remove the GBIB Interfaces (if installed) listed under the Device
Manager and shut down the computer.
Control Panel, double- click System, Hardware Tab,
Device Manager, GPIB Interfaces
3 Physically remove the GPIB card from the computers PCI Interface.
4 Restart the computer and log on to the system. Install the Agilent IO
Libraries Suite.
Do not configure the card at this time and shut down the computer.
5 Install the GPBI card again and turn on the computer - the new
hardware found wizard will indicate that a PCI card is found. Select the
second choice to search from a list of known devices and there select
the option for Agilent Technologies, since the IO Libraries are already
installed.
To Next Page
Loading...
Need help?
General
