Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide 141
Safety Information A
Warning and Caution Messages
Electromagnetic Compatibility
EN55011/CISPR11
Group 1 ISM equipment contains all ISM equipment in which there is
intentionally generated and/or used, conductively coupled radio- frequency
energy which is necessary for the internal functioning of the equipment
itself.
Class A equipment is equipment suitable for use in all establishments
other than domestic and those directly connected to a low voltage power
supply network which supplies buildings used for domestic purposes.
This device complies with the requirements of CISPR11, Group 1, Class A
as radiation professional equipment. Therefore, there may be potential
difficulties in ensuring electromagnetic compatibility in other environments
due to conducted as well as radiated disturbances.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including
interference that may cause undesired operation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try one or more of the following measures:
1 Relocate the radio or antenna.
2 Move the device away from the radio or television.
3 Plug the device into a different electrical outlet, so that the device and
the radio or television are on different electrical circuits.
4 Make sure that all peripheral devices are also certified.
5 Make sure that appropriate cables are used to connect the device to
peripheral equipment.
6 Consult your equipment dealer, Agilent Technologies, or an experienced
technician for assistance.
Changes or modifications not expressly approved by Agilent Technologies
could void the user’s authority to operate the equipment.
To Next Page
Loading...
Need help?
General
