64 Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
4 Installing Accessories
Optical Filter Wheel
filter wheel assembly should fit into the holes in the clamp. The base of
the filter wheel assembly should be against the base of the cell holder.
6 Tighten the screws that hold the clamp.
Removing the Filter Wheel Assembly
1 Loosen but do not remove the two screws that hold the clamp.
2 Separate the filter wheel assembly from the cell holder.
3 The filter wheel clamp may be left in place or removed. In either case,
retighten the two screws.
4 Store the filter wheel in a clean plastic bag.
To Next Page
Loading...
Need help?
General
