ESG-D Series Option H98 Signal Generators Programming Information
Wideband CDMA Subsystem SCPI Command Reference
Manual Supplement 5-19
Downlink Channel 1 Symbol Rates
The following downlink channel 1 symbol rates are assigned by appending the
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:SRATe command with one of the
following variables:
SR32K Sets the downlink channel 1 symbol rate to 32 kilosymbols per second.
SR64K Sets the downlink channel 1 symbol rate to 64 kilosymbols per second.
SRV64K Sets the downlink channel 1 symbol rate to 64 kilosymbols per second
voice.
SR128K Sets the downlink channel 1 symbol rate to 128 kilosymbols per second.
SR256K Sets the downlink channel 1 symbol rate to 256 kilosymbols per second.
Status after *RST: 32 ksps
Uplink Channel 1 Symbol Rates
The following uplink channel 1 symbol rates are assigned by appending the
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:SRATe command with one of the
following variables:
SR32K Sets the uplink channel 1 symbol rate to 32 kilosymbols per second.
SR64K Sets the uplink channel 1 symbol rate to 64 kilosymbols per second.
SRV64K Sets the uplink channel 1 symbol rate to 64 kilosymbols per second voice.
SR128K Sets the uplink channel 1 symbol rate to 128 kilosymbols per second.
SR256K Sets the uplink channel 1 symbol rate to 256 kilosymbols per second.
Status after *RST: 32 ksps
Uplink Channel 2 and 3 Symbol Rates
The following uplink channel 2 and 3 symbol rates are assigned by appending the
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel2:SRATe and
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel3:SRATe commands with one of the
following variables:
SR32K Sets uplink channels 2 or 3 symbol rate to 32 kilosymbols per second.
SR64K Sets uplink channels 2 or 3 symbol rate to 64 kilosymbols per second.
SR128K Sets uplink channels 2 or 3 symbol rate to 128 kilosymbols per second.
SR256K Sets uplink channels 2 or 3 symbol rate to 256 kilosymbols per second.
Status after *RST: 32 ksps
NOTE 64 ksps voice is not available for channels 2 or 3.