Agilent Technologies G8610A - Page 47

Agilent Technologies Helium Leak Detector
DRAFT 12/11/17
47
Maintenance
❑ General - Configures:
❑ Internal Calibrated Leak Setup & Expiration
❑ Software Update Utility
❑ Manual Tuning - Configures:
❑ Toggles between Filament 1 & 2
❑ Sets Emission, Ion and Gain settings
❑ Valve Control - Configures:
❑ Access to control and monitor valves
❑ Monitor turbo pump parameters
❑ Pump - Configures:
❑ Fore Pump description type, operating hours and Last Service Date
❑ Enable Exhaust Pump
❑ Gauge Calibration - Configures:
❑ Calibrates the Test Port TC's Vacuum and ATM reference points
❑ Displays Test port and spectrometer pressures
❑ System Defaults - Configures:
❑ Ability to reset Turbo and Filament hours for maintenance purposes
❑ Ability to reset back to Factory Defaults
System Information:
❑ Displays part number and serial number
❑ Display Software Version
❑ Displays the status of the spectrometer and turbo pump parameters
❑ Current Setup
❑ Displays the status of active items
Table 1-3 Screens – General Description (Continued)
Screen Purpose