Ainuo AN9640B - Storage and Transport; Storage; Transport

Chapter 6 Maintenance
48
1
LCD no display after Start.
Check and make sure the power line is connected relaibly.
2
Abnormal protection during
ACW/DCW/IR.
Check ACW/DCW /IR lines for short circuit and correct.
3
Abnormal protection during GB.
Check GB line for open circuit and correct.
4
Analyzer crashed.
Shutdown and re-start after 30s.
5
Communication failure between
the analyzer and PC.
1. Start the PC before Start the analyzer for the
communication system.
2. Check and make sure the cable is connected reliably.
3. Check and make sure the software is installed well.
4. Check and make sure the serial port is correct.
5. Check and make sure the setting of address for the
analyzer meet communication requirements for PC.
6. Check and make sure the baud rate of PC is consistent
with that of the analyzer.
6
During import/export of test file,
the U disk cannot be identified
Check if the U disk meets requirements in section 2.3.
6.3 Storage and Transport
6.3.1 Storage
Temperature: -10℃~+50℃ Relative humidity: 0~90%RH
Take dust measures during storage. Never place any
objectsion the analyzer.
6.3.2 Transport
1 Package
Keep the instrument in original package for repair or transport. If it is impossible to pack
the instrument using the original packing materials, handle according to the following:
a Wrap the instrument well;
b Place the instrument in a wooden or multi-layer paper box (Load: 150kg);
c Fill around the instrument using shock-proof materials (70~100mm thick). Protect the
panels using foam;
d Seal the box properly.Label Fragile, Handle with Care at eye-attracting position.
Pack the power line, test line and all attachments with
the analyzer for repair. Please note the fault.
2 Transport
Avoid bumps, rough handle, rain and upside-down during transport.