Chapter 3 Unpack and Installation
17
3.4.2 ESRSSystem software operation flow
The operation process of the ESRS system test software is as follows:
In control mode:
The first step is to enter the "Hardware Configuration" module and configure the tester
device parameters you want to control. This step is generally only required once, unless you
change the hardware configuration of the device, you need to re-enter the module settings.
The second step is to enter the "program editing" module to edit the test project process and
parameters you want to carry out.
The third step is to enter the "System Management" module and publish the test program you
just edited.
The fourth step is to enter the "Product Test" module and open the test program you just
edited to start the test.
The fifth step, enter the "report generation" module, you can query and count test data, and
generate reports.
In query mode:
The first step is to enter the "Hardware Configuration" module and configure the tester
device parameters you want to query. This step is generally only required once, unless you change
the hardware configuration of the device, you need to re-enter the module settings.
The second step is to enter the "Product Test" module, open the hardware configuration file
you just edited, and you can start the query.
The third step, enter the "report generation" module, you can query and count test data, and
generate reports.
3.4.3 System Management
Select the system management option in the main interface of the system ESRS system
software, and the system management interface as shown in Figure 3-2-4 will be displayed.
To Next Page
Loading...
