Page 136
glid Flight Mode menu
Choosing the Flight Mode - Common or Separate
When set to COM (Common), the TRIM STEP settings will be the same regardless of which Flight Mode the transmitter is operating
in. You cannot program TRIM STEP settings separately for each Flight Mode. When set to SEP (Separate), you can program
different TRIM STEP settings separately for each Flight Mode.
3) Press the F-MODE key to choose the F-MODE number you would like to program the Trim Step function for. Choose from N,
1, 2, 3, or 4. The NORMAL (N) display will change, indicating which Flight Mode you are programming the Trim Step function for.
1) Press the Navigation Pad
56
to highlight TRIM STEP, then press the
ENTER key to display the TRIM STEP menu. The cursor will default to
COMMON>COM.
2) Press the YES/+ or NO/- keys to choose either COM or SEP. If set to
COM, skip to the Setting the Trim Step Values section. If set to SEP,
see step 3 below.
Changing the Trim Step Values
1) Press the Navigation Pad
3456
to highlight the channel you would
like to change the Trim Step value for, then press the YES/+ or NO/- keys
to change the Trim Step value.
TRIM STEP setting range is 1 to 30. The default setting is 6. Increasing the Trim Step value causes the servo to travel more
when the trim switch is moved (lower resolution). Decreasing the Trim Step value causes the servo to move less when the trim
switch is moved (higher resolution).
The CB-PRESET channel controls the Camber Preset and is assigned
to the Trim Switch (T5).
Choosing the Flight Mode - Common or Separate
When set to COM (Common), the TRIM AUTH settings will be the same regardless of which Flight Mode the transmitter is operating
in. You cannot program TRIM AUTH settings separately for each Flight Mode. When set to SEP (Separate), you can program
different TRIM AUTH settings separately for each Flight Mode.
The Trim Authority function allows you to change the amount of Camber or Reex travel relative to how far Auxiliary Lever (VR6)
is moved. For example, if you set the Trim Authority Camber percentage value to 50%, the trailing edge will move half as much
using Auxiliary Lever (VR6) as it would if the Trim Authority Camber percentage value was set to 100%. You can choose to
program Trim Authority values separately for each of the ve Flight Modes or you can use the same Trim Authority programming
values across all ve Flight Modes.
Transmitter F-MODE
Programming F-MODE
Transmitter F-MODE refers to the Flight Mode that the transmitter is currently operating in. Programming F-MODE refers
to the Flight Mode that you would like to change the programming for.
Auxiliary Lever (VR6)
Camber
To Next Page
Loading...
