System Resource-Profile Commands
Page 428 7210 SAS M, T, X, R6 Basic System Configuration
Guide
max — It is a special keyword. If user specifies max, then the software allocates one chunk when the
first SAP is associated with a ingress filter policy using this match criteria. It continues to allocate
resources to the service entity associated with a ingress filter policy using this criteria, as long as the
total amount of resources allocated does not exceed the resources allocated to ingress filter policies
(configured with the command config> system> resource-profile> ingress-internal-tcam> acl-sap-
ingress command) and chunks are available for use.
On 7210 SAS-X, it is further limited by the limit applicable for the individual match criteria.
ipv4-mac-match-enable
Syntax [no] ipv4-mac-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Description This command allows the user to allocate maximum resources for use by SAP ingress QoS policies
using both MAC (any) and IPv4 criteria (any) criteria in a policy.
The available resources is used by software to allocate resources for SAP ingress policies using the
following criteria - either both IPv4 criteria any and MAC criteria any, only mac criteria any, only
ipv4 criteria, dot1p-only criteria, ipv4 dscp-only criteria and ipv6 dscp-only criteria. It is not used for
SAP ingress policies that use ipv6 criteria any.
For more information on resource allocation details and fields available for use, see the 7210 SAS
QoS User Guides.
With the no form of the command, the software does not allocate any resources for use by SAP
ingress QoS policies using both MAC and IPv4 criteria. If no resources are allocated for use, then
software fails all attempts to associate a service entity (For example: SAP, IP interface, etc.) with a
ingress filter policy or SAP ingress QoS policy using this match criteria.
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 5 0
7210 SAS-X (per node) 0 2 0
7210 SAS-T Access-Uplink
mode (per node)
0 7 3
7210 SAS-T Network Mode
(per node)
0 6 3
7210 SAS-R6 (per IMM) 0 (per IMM) max number
of slices
assigned to
acl (per IMM)
max
To Next Page
Loading...
