System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 429
Parameters num-resources — Specifies the maximum amount of resources for use by this match criteria..
max — It is a special keyword. If user specifies max, then the software allocates one chunk when the
first SAP is associated with a ingress filter policy using this match criteria. It continues to allocate
resources to SAPs associated with a ingress filter policy using this criteria, as long as the total amount
of resources allocated does not exceed the resources allocated to ingress filter policies (configured
with the command config> system> resource-profile> ingress-internal-tcam> acl-sap-ingress
command) and chunks are available for use.
NOTE: On 7210 SAS-X, it is further limited by the limit applicable for the individual match criteria.
ipv4-match-enable
Syntax [no] ipv4-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Description This command allows the user to allocate maximum resources for use by ingress filter policies using
ipv4 criteria. Or when used under the qos-sap-ingress-resource context, its used to allocates resources
for use by SAP ingress QoS policies using IPv4 criteria (any).
The resource cannot be shared with ingress filter or SAP ingress QoS filter policies using mac criteria
or ipv6 criteria. Please see the 7210 SAS Router Configuration guide for more information on
resource allocation details and fields available for use.
With the no form of the command, the software does not allocate any resources for use by ingress
filter policies or SAP ingress QoS policies using ipv4 criteria. If no resources are allocated for use,
then software fails all attempts to associate a service entity (For example: SAP, IP interface, etc.) with
a ingress filter policy or SAP ingress QoS policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
max — It is a special keyword. If user specifies max, then the software allocates one chunk when the
first SAP is associated with a ingress filter policy using this match criteria. It continues to allocate
resources to SAPs associated with a ingress filter policy using this criteria, as long as the total amount
of resources allocated does not exceed the resources allocated to ingress filter policies (configured
with the command config> system> resource-profile> ingress-internal-tcam> acl-sap-ingress
command) and chunks are available for use.
On 7210 SAS-X, it is further limited by the limit applicable for the individual match criteria.
To Next Page
Loading...
