Alcatel-Lucent 7210 SAS M Configuration Guide

System Resource-Profile Commands
Page 430 7210 SAS M, T, X, R6 Basic System Configuration
Guide
ipv6-64-only-match-enable
Syntax [no] ipv6-64-only-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
Description This command allows the user to allocate maximum resources for use by ingress filter policies using
ipv6 criteria with 64-bit IPv6 addresses. Please see the 7210 SAS Router Configuration guide for
more information on resource allocation details and fields available for use.
The resources cannot be shared with IPv4 filter policies or IPv6 filter policies specifying 128-bit
addresses.
With the no form of the command, the software does not allocate any resources for use by filter
policies using ipv6 criteria with 64-bit IPv6 addresses. If no resources are allocated for use, then
software fails all attempts to associate a service entity (For example: SAP, IP interface, etc.) with a
ingress filter policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
max — It is a special keyword. If user specifies max, then the software allocates one chunk when the
first SAP is associated with a ingress filter policy using this match criteria. It continues to allocate
resources to SAPs associated with a ingress filter policy using this criteria, as long as the total amount
of resources allocated does not exceed the resources allocated to ingress filter policies (configured
with the command config> system> resource-profile> ingress-internal-tcam> acl-sap-ingress
command) and chunks are available for use.
NOTE: On 7210 SAS-X, it is further limited by the limit applicable for the individual match criteria.
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 5 max
7210 SAS-X (per node) 0 2 max
7210 SAS-T Access-Uplink
mode (per node)
0 7 max
7210 SAS-T Network Mode
(per node)
0 6 max
7210 SAS-R6 (per IMM) 0 (per IMM) max number
of slices
assigned to
acl (per IMM)
max

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English