SDP Commands
Page 108 7210 SAS-X, R6 OS Services Guide
path-mtu
Syntax path-mtu bytes
no path-mtu
Context config>service>sdp
Description This command configures the Maximum Transmission Unit (MTU) in bytes that the Service
Distribution Point (SDP) can transmit to the far-end device router without packet dropping or IP
fragmentation overriding the SDP-type default path-mtu.
The default SDP-type path-mtu can be overridden on a per SDP basis. Dynamic maintenance
protocols on the SDP like RSVP may override this setting.
If the physical mtu on an egress interface indicates the next hop on an SDP path cannot support the
current path-mtu, the operational path-mtu on that SDP will be modified to a value that can be
transmitted without fragmentation.
The no form of this command removes any path-mtu defined on the SDP and the SDP will use the
system default for the SDP type.
Default The default path-mtu defined on the system for the type of SDP is used.
To Next Page
Loading...
