Alcatel-Lucent 7210 SAS-X - Configuring a VPLS Service with CLI

Virtual Private LAN Services
7210 SAS-X, R6 OS Services Guide Page 291
Configuring a VPLS Service with CLI
VPLS This section provides information to configure VPLS services using the command line interface.
Topics in this section include:
• Basic Configuration on page 292
• Common Configuration Tasks on page 294
→ Configuring VPLS Components on page 295
− Creating a VPLS Service on page 296
− Configuring a VPLS SAP on page 303
• Configuring VPLS SAPs with per service Split Horizon on page 312
• Configuring VPLS Redundancy on page 315
− Creating a Management VPLS for SAP Protection on page 315
− Configuring Load Balancing with Management VPLS on page 320
• Service Management Tasks on page 330
→ Modifying VPLS Service Parameters on page 330
→ Modifying Management VPLS Parameters on page 331
→ Deleting a VPLS Service on page 333
→ Disabling a VPLS Service on page 333
→ Re-Enabling a VPLS Service on page 334