Alcatel-Lucent 7210 SAS-X - Basic Configuration

Configuring a VPLS Service with CLI
Page 292 7210 SAS-X, R6 OS Services Guide
Basic Configuration
The following fields require specific input (there are no defaults) to configure a basic VPLS
service:
• Customer ID (refer to Configuring Customers on page 63)
• For a local service, configure two SAPs, specifying local access ports and encapsulation
values.
• For a distributed service, configure a SAP and an SDP for each far-end node.
The following example displays a sample configuration of a local VPLS service on ALA-1.
*A:ALA-1>config>service>vpls# info
----------------------------------------------
...
vpls 9001 customer 6 create
description "Local VPLS"
stp
shutdown
exit
sap 1/2/2:0 create
description "SAP for local service"
exit
sap 1/1/5:0 create
description "SAP for local service"
exit
no shutdown
----------------------------------------------
*A:ALA-1>config>service>vpls#
*A:ALA-1>config>service# info
----------------------------------------------
...
vpls 7 customer 7 create
stp
shutdown
exit
sap 1/1/21 create
exit
sap lag-1:700 create
exit
no shutdown
exit
...
----------------------------------------------
*A:ALA-1>config>service#
The following example displays a sample configuration of a distributed VPLS service between
ALA-1, ALA-2, and ALA-3.
*A:ALA-1>config>service# info
----------------------------------------------
...
vpls 9000 customer 6 create