Services
7210 SAS-X, R6 OS Services Guide Page 55
Configuration guidelines for G.8032
The following are the configuration guidelines for G.8032:
• Service level MEPs are not available on all SAPs tied to an Eth-ring instance on a port.
• G8032 instances cannot be configured over a LAG.
• For 7210 SAS-X devices, to improve the service fail-over time due to failures in the ring
path, fast flood is enabled by default. On a failure detection in one of the paths of the eth-
ring, along with MAC flush the system starts to flood the traffic onto the available
path.No explicit user configuration is needed for this and it does not affect scaling for
filters.
• On 7210 SAS-R6, user can enable G8032 fast-flood by allocating resources to this feature
using the command configure> system> global-system-profile> sf-ingress-internal-
tcam> g8032-fast-flood.
To Next Page
Loading...
