Alcatel-Lucent 7210 SAS-X - Table 14: Final Disposition of the Packet Based on Per FC and Per SAP Policer or Meter

VPRN Service Configuration Commands
Page 778 7210 SAS-X OS Services Guide
Table 14: Final Disposition of the packet based on per FC and per SAP policer or meter.
Note*: The row number 2 in the above table is not recommended for use. For more informa-
tion on this, see the Note in the “aggregate-meter-rate” description.
When the SAP aggregate policer is configured, per FC policer can be only configured in “trtcm2”
mode (RFC 4115).
Note: The meter modes “srtcm” and “trtcm1” are used in the absence of an aggregate meter.
The SAP ingress meter counters increment the packet or octet counts based on the final disposition of
the packet.
If ingress Frame-based accounting is used, the SAP aggregate meter rate accounts for the Ethernet
frame overhead. The system accounts for 12 bytes of IFG and 8 bytes of start delimiter.
The no form of the command removes the aggregate policer from use.
Default no aggregate-meter-rate
Parameters rate-in-kbps — Specifies the rate in kilobits per second.
Values 01 — 20000000 | max
Default max
burst <burst-in-kilobits> — Specifies the burst size for the policer in kilobits. The burst size cannot
be configured without configuring the rate.
Values 4 —2146959
Default 512
hsmda-queue-override
Syntax [no] hsmda-queue-override
Context config>service>vprn>if>sap>egress
config>service>vprn>if>sap>ingress
Description This command enables the context to configure HSMDA queue overrides.
Above PIR Red Above PIR Red Red or
Dropped
Per FC meter
Operating
Rate
Per FC
Assigned
Color
SAP aggre-
gate meter
Operating
Rate
SAP aggre-
gate meter
color
Final Packet
Color