Alcatel-Lucent 7210 SAS-X - Configuring a VPLS SAP

Virtual Private LAN Services
7210 SAS-X, R6 OS Services Guide Page 303
Configuring a VPLS SAP
A default QoS policy is applied to each ingress SAP. Additional QoS policies can be configured in
the config>qos context. There are no default filter policies. Filter policies are configured in the
config>filter context and must be explicitly applied to a SAP.
VPLS S AP Use the following CLI syntax to create:
• Local VPLS SAPs on page 303
• Distributed VPLS SAPs on page 304
Local VPLS SAPs
To configure a local VPLS service, enter the sap sap-id command twice with different port IDs in
the same service configuration.
The following example displays a local VPLS configuration:
*A:ALA-1>config>service# info
----------------------------------------------
vpls 1150 customer 1 create
fdb-table-size 1000
fdb-table-low-wmark 5
fdb-table-high-wmark 80
local-age 60
stp
shutdown
exit
sap 1/1/1:1155 create
exit
sap 1/1/2:1150 create
exit
no shutdown
exit
----------------------------------------------
*A:ALA-1>config>service#