Alcatel-Lucent 7210 SAS-X - Configuring as Pseudo-Wire in VPLS; Figure 45: Sample Topology-AS Pseudo-Wire in VPLS

Configuring a VPLS Service with CLI
Page 328 7210 SAS-X, R6 OS Services Guide
Configuring AS Pseudo-wire in VPLS
Figure 45: Sample Topology-AS Pseudo-wire in VPLS
In Figure 45, Pseudo-wire is configured on MTU. A sample configuration on the MTU is listed
below:
*A:MTU>config>service>vpls>endpoint# back
*A:MTU>config>service>vpls# info
----------------------------------------------
send-flush-on-failure
stp
shutdown
exit
endpoint "vpls1" create
description "vpls1_endpoint"
revert-time 60
ignore-standby-signaling
no suppress-standby-signaling
block-on-mesh-failure
exit
sap 1/1/3 create
exit
spoke-sdp 301:1 endpoint "vpls1" create
stp
shutdown
exit
block-on-mesh-failure
exit
spoke-sdp 302:1 endpoint "vpls1" create
stp
shutdown
exit
block-on-mesh-failure
exit
no shutdown
----------------------------------------------
*A:MTU>config>service>vpls#
PE-A
PE-A
PE-C
MTU