ETH-CFM Configuration Commands
Page 118 7210 SAS-X, R6 OS Services Guide
Parameters default — Specifies that MHFs can be created for this VID only on bridge ports through which this
VID can pass without the requirement for a MEP at some lower MA level. On 7210 SAS-X, this
parameter can be used only for MIP creation in an Epipe service and it is not supported for MIP
creation in a VPLS service. On 7210 SAS-R6, it is supported for Ingress MIPs only in a VPLS
service and it is not supported for MIP creation in an Epipe service.
none — Specifies that no MHFs can be created for this VID.
explicit — Specifies that MHFs can be created for this VID only on bridge ports through which this
VID can pass, and only if a MEP is created at some lower MA level. There must be at least one
lower level MEP provisioned on the same SAP.
vlan
Syntax vlan vlan-id
no vlan
Context config>>domain>association>bridge-identifier
Description This command configures the bridge-identifier primary VLAN ID. Note that it is informational only,
and no verification is done to ensure MEPs on this association are on the configured VLAN.
Parameters vlan-id — Specifies a VLAN ID monitored by MA.
Values 0 — 4094
ccm-interval
Syntax ccm-interval {1 | 10 | 60 | 600}
no ccm-interval
Context config>>domain>association
Description This command configures the CCM transmission interval for all MEPs in the association.
Table 7: CCM transmission interval for 7210 SAS-X and 7210 SAS-R6
The no form of the command reverts the value to the default.
Default 10 seconds
Parameters interval — Specifies the interval between CCM transmissions to be used by all MEPs in the MA.
MEP Timer Sup-
port
7210 SAS-X 7210 SAS-R6
Service Down MEP 1s 1s
G8032 Down MEP 100ms 10ms
Service UP MEP 1s 1s
To Next Page
Loading...
