Alcatel-Lucent 7210 SAS-X - PBB Show Commands

PBB Show Commands
7210 SAS-X, R6 OS Services Guide Page 599
PBB Show Commands
PBB
the qtag value.
mip
Syntax mip
Context show>eth-cfm>mip
Description This command displays Maintenance Intermediate Point (MIP) information only in 7210 SAS-M and
7210 SAS-T network mode and SASX.
Output Show Output — The following table describes the show all service-id command output fields:
Sample
*A:7210SAS# show eth-cfm mip
==========================================================================
CFM SAP MIP Table
==========================================================================
Sap Mip-Enabled Mip Mac Address
--------------------------------------------------------------------------
1/1/16 yes 00:a1:b1:c1:d1:e1
==========================================================================
==========================================================================
CFM SDP MIP Table
==========================================================================
Sdp Mip-Enabled Mip Mac Address
--------------------------------------------------------------------------
456:123 yes 00:a2:b2:c2:d2:e2
==========================================================================
*A:7210SAS#
id
Syntax id service-id
Context show>service
Label Description
Mip-Enabled Displays the state of the MIP service
Mip Mac Address Indicates the Mac Address of the MIP