Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 155
Epipe Configuration for MPLS-TP
Note: . MPLS-TP PWs are supported in Epipe service. MPLS-TP is supported only on 7210 SAS-
R6. It is not supported on 7210 SAS-X.
The following subsections describe how SDPs and spoke-SDPs are used with MPLS-TP LSPs and
static PWs with MPLS-TP OAM.
SDPs
An SDP used for MPLS-TP supports the configuration of an MPLS-TP identifier as the far end
address, as an alternative to an IP address. IP addresses are used if IP/MPLS LSPs are used by the
SDP, or MPLS-TP tunnels identified by IPv4 source or destination addresses. MPLS-TP node
identifiers are used if MPLS-TP tunnels are used.
The following CLI shows the new MPLS-TP options:.
config
service
sdp
no description
network-domain "default"
signaling off
far-end node-id 0.0.0.43 global-id 4294967295
no mixed-lsp-mode
no ldp
no bgp-tunnel
lsp "unnumberedLSP"
no vlan-vc-etype
no pbb-etype
no path-mtu
no adv-mtu-override
keep-alive
shutdown
hello-time 10
hold-down-time 10
max-drop-count 3
timeout 5
no message-length
exit
no metric
no collect-stats
no accounting-policy
binding
no port
exit
no shutdown
----------------------------------------------
*A:7210SAS>config>service>sdp#
To Next Page
Loading...
