Alcatel-Lucent 7210 SAS-X - Applying ETH-CFM Parameters

Ethernet Connectivity Fault Management (ETH-CFM)
Page 78 7210 SAS-X, R6 OS Services Guide
Applying ETH-CFM Parameters
Apply ETH-CFM parameters to the following entities.
CLI Syntax: config>service>epipe>sap
eth-cfm
mep mep-id domain md-index association ma-index [direction
{up | down}]
ais-enable
client-meg-level [[level [level ...]]
interval {1 | 60}
priority priority-value
ccm-enable
ccm-ltm-priority priority
eth-test-enable
test-pattern {all-zeros | all-ones} [crc-enable]
low-priority-defect {allDef | macRemErrXcon | remEr-
rXcon | errXcon | xcon | noXcon}
[no] shutdown
CLI Syntax: config>service>epipe>spoke-sdp
eth-cfm
mep mep-id domain md-index association ma-index [direction
{up | down}]
ccm-enable
ccm-ltm-priority priority
eth-test-enable
test-pattern {all-zeros | all-ones} [crc-enable]
low-priority-defect {allDef|macRemErrXcon|remErrXcon|
errXcon|xcon|noXcon}
[no] shutdown
CLI Syntax: config>service>vpls>sap
eth-cfm
mip
mep mep-id domain md-index association ma-index [direction
{up | down}]
no mep mep-id domain md-index association ma-index
ccm-enable
ccm-ltm-priority priority
eth-test-enable
test-pattern {all-zeros | all-ones} [crc-enable]
low-priority-defect {allDef|macRemErrXcon|remErrX-
con|errXcon|xcon|noXcon}
mac-address mac-address
[no] shutdown