Subscriber Services
7210 SAS-X, R6 OS Services Guide Page 117
Description This command configures the Maintenance Association (MA) for the domain.
Parameters ma-index — Specifies the MA index value.
Values 1 — 4294967295
format {icc-based | integer | string | vid | vpn-id} — Specifies a value that represents the type
(format).
Values icc-based: Only applicable to a Y.1731 context where the domain format is
configured as none. Allows for exactly a 13 character name.
integer: 0 — 65535 (integer value 0 means the MA is not attached to a VID.)
string: raw ascii
vid: 0 — 4095
vpn-id: RFC-2685, Virtual Private Networks Identifier
xxx:xxxx, where x is a value between 00 and FF.
for example 00164D:AABBCCDD
Default integer
name ma-name — Specifies the part of the maintenance association identifier which is unique within
the maintenance domain name.
Values 1 — 45 characters
bridge-identifier
Syntax [no] bridge-identifier bridge-id
Context config>>domain>association
Description This command configures the service ID for the domain association. The value must be configured to
match the service-id of the service where MEPs for this association will be created. Note that there is
no verification that the service with a matching service-id exists. This is not used for facility MEPs as
they are not tied to services.
Parameters bridge-id — Specifies the bridge ID for the domain association.
Values 1 — 2147483647
mhf-creation
Syntax mhf-creation {default | none | explicit}
no mhf-creation
Context config>>domain>association>bridge-identifier
Description This command determines whether to allow automatic MIP creation for the MA.
NOTE: Please refer to ETH-CFM Support Matrix for 7210 SAS-X devices on page 74ETH-CFM
Support Matrix for 7210 SAS-R6 devices on page 74for MEP and MIP support available for different
services on different platforms
Default none
To Next Page
Loading...
