ETH-CFM Configuration Commands
Page 116 7210 SAS-X, R6 OS Services Guide
Parameters mac-address — Specifies the MAC address of the MEP.
Values 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx) of the MEP.
Using the all zeros address is equivalent to the no form of this command.
Default no mac-address
domain
Syntax domain md-index [format md-name-format] [name md-name] level level
domain md-index
no domain md-index
Context config>eth-cfm
Description This command configures Connectivity Fault Management domain parameters.
The no form of the command removes the MD index parameters from the configuration.
Parameters md-index — Specifies the Maintenance Domain (MD) index value.
Values 1 — 4294967295
format {dns | mac | none | string} — Specifies a value that represents the type (format).
Values dns: Specifies the DNS name format.
mac: X:X:X:X:X:X-u
X: [0..FF]h
u: [0..65535]d
none: Specifies a Y.1731 domain format and the only format allowed to
execute Y.1731 specific functions.
string Specifies an ASCII string.
Default string
name md-name — Specifies a generic Maintenance Domain (MD) name.
Values 1 — 43 characters
level level — Specifies the integer identifying the maintenance domain level (MD Level). Higher
numbers correspond to higher maintenance domains, those with the greatest physical reach, with
the highest values for customers' CFM packets. Lower numbers correspond to lower maintenance
domains, those with more limited physical reach, with the lowest values for single bridges or
physical links.
Values 0 — 7
association
Syntax association ma-index [format ma-name-format] name ma-name
association ma-index
no association ma-index
Context config>>domain
To Next Page
Loading...
