Alcatel-Lucent 7210 SAS-X - Page 304

Configuring a VPLS Service with CLI
Page 304 7210 SAS-X, R6 OS Services Guide
Distributed VPLS SAPs
To configure a distributed VPLS service, you must configure service entities on originating and
far-end nodes. You must use the same service ID on all ends (for example, create a VPLS service
ID 9000 on ALA-1, ALA-2, and ALA-3). A distributed VPLS consists of a SAP on each
participating node and an SDP bound to each participating node.
For SDP configuration information, see Configuring an SDP on page 65. For SDP binding
information, see Configuring SDP Bindings on page 313.
The following example displays a configuration of VPLS SAPs configured for ALA-1, ALA-2,
and ALA-3.
*A:ALA-3>config>service# info
----------------------------------------------
vpls 1150 customer 1 create
fdb-table-size 1000
fdb-table-low-wmark 5
fdb-table-high-wmark 80
local-age 60
stp
shutdown
exit
sap 1/1/1:1155 create
exit
sap 1/1/2:1150 create
exit
no shutdown
exit
----------------------------------------------
*A:ALA-3>config>service#