Configuring a VLL Service with CLI
Page 172 7210 SAS-X, R6 OS Services Guide
Distributed Epipe Service
To configure a distributed Epipe service, you must configure service entities on the originating
and far-end nodes. You should use the same service ID on both ends (for example, Epipe 5500 on
ALA-1 and Epipe 5500 on ALA-2). The spoke-sdp sdp-id:vc-id must match on both sides. A
distributed Epipe consists of two SAPs on different nodes.
By default QoS policy ID 1 is applied to ingress service SAPs. On egress, QoS policies are
associated with a port. Existing filter policies can be associated with service SAPs on ingress and
egress.
Meters (defined in sap-ingress policies) can be applied on ingress. It is associated with SAPs.
Scheduler Policies can be applied on egress. It is associated with a port.
Ingress and egress SAP parameters can be applied to local and distributed Epipe service SAPs.
For SDP configuration information, see Configuring an SDP on page 65. For SDP binding
information, see Configuring SDP Bindings on page 175.
This example configures a distributed service between ALA-1 and ALA-2.
A:ALA-1>epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe service to east coast"
config>service>epipe# sap 221/1/3:21 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 555
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# no shutdown
config>service>epipe>sap# exit
config>service>epipe#
A:ALA-2>config>service# epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe service to west coast"
config>service>epipe# sap 441/1/4:550 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# filter ip 1020
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# egress
config>service>epipe>sap>egress# filter ip 6
config>service>epipe>sap>egress# exit
config>service>epipe>sap# no shutdown
config>service>epipe#
The following example displays the SAP configurations for ALA-1 and ALA-2:
A:ALA-1>config>service# info
----------------------------------------------
...
epipe 5500 customer 5 vpn 5500 create
description "Distributed epipe service to east coast"
sap 221/1/3:21 create
ingress
qos 555
filter ip 1
exit
To Next Page
Loading...
