Configuring a VLL Service with CLI
Page 174 7210 SAS-X, R6 OS Services Guide
Configuring Ingress SAP Parameters
By default, QoS policy ID 1 is applied to ingress service SAPs. Existing filter policies or other
existing QoS policies can be associated with service SAPs on ingress and egress ports.
Ingress and egress SAP parameters can be applied to local and distributed Epipe service SAPs.
This example displays SAP ingress and egress parameters.
ALA-1>config>service# epipe 5500
config>service>epipe# sap
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 555
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# exit
config>service>epipe>sap#
The following example displays the Epipe SAP ingress configuration:
A:ALA-1>config>service#
----------------------------------------------
...
epipe 5500 customer 5 vpn 5500 create
description "Distributed epipe service to east coast"
sap 1/1/3:21 create
ingress
qos 555
filter ip 1
exit
exit
no shutdown
exit
----------------------------------------------
A:ALA-1>config>service#
To Next Page
Loading...
