Alcatel-Lucent 7210 SAS-X - Page 180

Configuring a VLL Service with CLI
Page 180 7210 SAS-X, R6 OS Services Guide
pw-path-id
agi 1:1
saii-type2 1:0.0.0.1:1
taii-type2 1:0.0.0.2:1
exit
control-channel-status
refresh-timer 10
no shutdown
exit
no shutdown
exit
no shutdown
exit
----------------------------------------------
*A:7210SAS>config>service#
S-PE1: Note that specifying the vc-switching parameter enables a VC cross-connect so the service
manager does not signal the VC label mapping immediately but will put this into passive mode.
The following example displays the configuration:
*A:ALA-S-PE1>config>service>epipe# info
----------------------------------------------
...
spoke-sdp 2:200 create
exit
spoke-sdp 3:300 create
exit
no shutdown
----------------------------------------------
*A:ALA-S-PE1>config>service>epipe#
S-PE2: Note that specifying the vc-switching parameter enables a VC cross-connect so the service
manager does not signal the VC label mapping immediately but will put this into passive mode.
The following example displays the configuration:
*A:ALA-S-PE2>config>service>epipe# info
----------------------------------------------
...
spoke-sdp 2:200 create
exit
spoke-sdp 3:300 create
exit
no shutdown
----------------------------------------------
*A:ALA-S-PE2>config>service>epipe#