Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 203
Description The no form of this command disables the service MTU check.
Disabling service MTU check allows the packets to pass to the egress if the packet length is lesser
than or equal to the MTU configured on the port. The length of the packet sent from a SAP is limited
only by the access port MTU. In case of a pseudowire the length of a packet is limited by the network
port MTU (including the MPLS encapsulation).
Notes:
• If TLDP is used for signaling, the configured value for service-mtu is used during a pseudowire
setup.
• This command is supported on 7210 SAS-M and 7210 SAS-T in Network mode.
Default enabled
To Next Page
Loading...
