Alcatel-Lucent 7210 SAS-X - Page 208

VLL Service Configuration Commands
Page 208 7210 SAS-X, R6 OS Services Guide
llf
Syntax [no] llf
Context config>service>epipe>sap>ethernet
Description This command enables Link Loss Forwarding (LLF) on an Ethernet port. It provides an end-to-end
OAM fault notification for Ethernet VLL service.LLF on an Ethernet port brings down the port when
there is a local fault on the pseudowire or service, or a remote fault on the SAP or pseudowire,
signaled with label withdrawal or TLDP status bits. It ceases when the fault disappears.
The Ethernet port must be configured for null encapsulation.
The no form of the command disables LLF.
ignore-oper-down
Syntax [no] ignore-oper-down
Context config>service>epipe>sap
Description This command enables the user to configure the optional command for a specific SAP to ignore the
transition of the operational state to down when a SAP fails. Only a single SAP in an ePipe may use
this option.
Default no ignore-oper-down
Default
mip
Syntax mip [mac mac-address]
mip default-mac
no mip
Context config>service>epipe>sap>eth-cfm
config>service>epipe>spoke-sdp>eth-cfm
config>service>vpls>sap>eth-cfm (Supported only on 7210 SAS-R6)
config>service>vpls>spoke-sdp>eth-cfm (Supported only on 7210 SAS-R6)
Description This command allows Maintenance Intermediate Points (MIPs) to be created if mhf-creation for the
MA is configured using the default option.
Note: This command is supported on 7210 SAS-X, 7210 SAS-R6 (only under VPLS service, and not
under Epipe service), and 7210 SAS-M, 7210 SAS-T(Network and Access-uplink mode).
Parameters mac-address — Specifies the MAC address of the MIP.