Virtual Private LAN Services
Page 360 7210 SAS-X, R6 OS Services Guide
dot1q-range — Specifies that the access SAP in the service can use VLAN ranges as the SAP tags.
The VLAN ranges are configured using the CLI command configure> connection-profile. On
ingress of the access dot1q SAP using VLAN ranges, the received tag on the SAP is preserved. A
VPLS service with svc-sap-type set to dot1q-range is used for Epipe emulation with G8032 for
protection. For more information about the capabilities and restrictions, see Epipe Emulation
using Dot1q VLAN range SAP in VPLS with G8032 on page 287.
r-vpls — Allows this VPLS instance to be associated with an IP interface to provide R-VPLS
functionality. This parameter is supported on 7210 SAS-M, 7210 SAS-X and 7210 SAS-R6.
bgp
Syntax bgp
Context config>service>vpls
This command enables the context to configure the BGP related parameters to BGP AD.
block-on-mesh-failure
Syntax [no] block-on-mesh-failure
Context config>service>vpls>spoke-sdp
config>service>vpls>endpoint
Description This command enables blocking (brings the entity to an opererationally down state) after all
configured SDPs or endpoints are in opererationally down state. This event is signalled to
corresponding T-LDP peer by withdrawing service label (status-bit-signaling non-capable peer) or by
setting “PW not forwarding” status bit in T-LDP message (status-bit-signaling capable peer).
Default disabled
bpdu-translation
Syntax bpdu-translation {auto | pvst | stp}
no bpdu-translation
Context config>service>vpls>spoke-sdp
config>service>vpls>sap
Description This command enables the translation of BPDUs to a given format, meaning that all BPDUs
transmitted on a given SAP or spoke SDP will have a specified format.
The no form of this command reverts to the default setting.
Default no bpdu-translation
Parameters auto — Specifies that appropriate format will be detected automatically, based on type of bpdus
received on such port.
To Next Page
Loading...
