Virtual Private LAN Services
7210 SAS-X, R6 OS Services Guide Page 391
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
mac-address
Syntax mac-address mac-address
no mac-address
Context config>service>vpls>mesh-sdp>eth-cfm>mep
config>service>epipe>spoke-sdp>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the
MEP is on a SAP) or the bridge (if the MEP is on a spoke).
Parameters mac-address — Specifies the MAC address of the MEP.
Values 6-byte mac-address in the form of xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx of the
MEP. Must be unicast. Using the all zeros address is equivalent to the no form of
this command.
one-way-delay-threshold
Syntax one-way-delay-threshold seconds
Context config>service>vpls>sap>eth-cfm>mep
config>service>epipe>spoke-sdp>eth-cfm>mep
Description This command enables/disables eth-test functionality on MEP.
Parameters seconds — Specifies the one way delay threshold, in seconds.
Values 0..600
Default 3
tunnel-fault
Syntax tunnel-fault {accept | ignore}
Context config>service>vpls>eth-cfm
config>service>vpls>sap>eth-cfm
Description Allows the individual service SAPs to react to changes in the tunnel MEP state. When tunnel-fault
accept is configured at the service level, the SAP will react according to the service type, EPIPE will
set the operational flag and VPLS, IES and VPRN SAP operational state will become down on failure
or up on clear. This command triggers the OAM mapping functions to mate SAPs and bindings in an
EPIPE service as well as setting the operational flag. If AIS generation is the requirement for the
To Next Page
Loading...
