Alcatel-Lucent 7210 SAS-X - Page 398

Virtual Private LAN Services
Page 398 7210 SAS-X, R6 OS Services Guide
Parameters agg-rate — Defines the rate, in kilobits-per-second, that the maximum aggregate rate that the queues
on the SAP or MSS can operate.
Values 1 — 10000000, max
filter
Syntax filter ip ip-filter-id
filter ipv6 ipv6-filter-id
filter mac mac-filter-id
Context config>service>vpls>sap>egress
config>service>vpls>sap>ingress
config>service>vpls>spoke-sdp>egress
Description This command associates an IP filter policy or MAC filter policy with an ingress or egress Service
Access Point (SAP) or IP interface.
Filter policies control the forwarding and dropping of packets based on IP or MAC matching criteria.
There are two types of filter policies: IP and MAC. Only one type may be applied to a SAP at a time.
The filter command is used to associate a filter policy with a specified filter ID with an ingress or
egress SAP. The filter ID must already be defined before the filter command is executed. If the filter
policy does not exist, the operation will fail and an error message returned.
In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One exception
is non-IP packets are not applied to IP match criteria, so the default action in the filter policy applies
to these packets.
The no form of this command removes any configured filter ID association with the SAP or IP
interface. The filter ID itself is not removed from the system.
Special Cases VPLS — Both MAC and IP filters are supported on a VPLS service SAP.
Parameters ip ip-filter-id — Specifies IP filter policy. The filter ID must already exist within the created IP filters.
Values 1 — 65535
ipv6 ipv6-filter-id — Specifies the IPv6 filter policy. The filter ID must already exist within the
created IPv6 filters.
Values 1 — 65535
mac mac-filter-id — Specifies the MAC filter policy. The specified filter ID must already exist within
the created MAC filters. The filter policy must already exist within the created MAC filters.
Values 1 — 65535
qos
Syntax qos policy-id
no qos
Context config>service>vpls>sap>ingress