Virtual Private LAN Services
7210 SAS-X, R6 OS Services Guide Page 401
If ingress Frame-based accounting is used, the SAP aggregate meter rate accounts for the Ethernet
frame overhead. The system accounts for 12 bytes of IFG and 8 bytes of start delimiter.
The no form of the command removes the aggregate policer from use.
Default no aggregate-meter-rate
Parameters rate-in-kbps — Specifies the rate in kilobits per second.
Values 0 — 20000000 | max
Default max
burst <burst-in-kilobits> — Specifies the burst size for the policer in kilobits. The burst size cannot
be configured without configuring the rate.
Values 4 —2146959
Default 512
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>vpls>sap
Description This command creates the accounting policy context that can be applied to a SAP.
An accounting policy must be defined before it can be associated with a SAP.
If the policy-id does not exist, an error message is generated.
A maximum of one accounting policy can be associated with a SAP at one time. Accounting policies
are configured in the config>log context.
The no form of this command removes the accounting policy association from the SAP, and the
acccounting policy reverts to the default.
Default Default accounting policy.
Parameters acct-policy-id — Enter the accounting policy-id as configured in the config>log>accounting-policy
context.
Values 1 — 99
collect-stats
Syntax [no] collect-stats
Context config>service>vpls>spoke-sdp
config>service>vpls>mesh-sdp
config>service>vpls>sap
Description This command enables accounting and statistical data collection for either the SAP, network port, or
IP interface. When applying accounting policies the data, by default, is collected in the appropriate
records and written to the designated billing file.
To Next Page
Loading...
