Virtual Private LAN Services
Page 408 7210 SAS-X, R6 OS Services Guide
group
Syntax [no] group grp-address
Context config>service>vpls>sap>igmp-snooping>static
config>service>vpls>spoke-sdp>snooping>static
config>service>vpls>mesh-sdp>snooping>static
This command adds a static multicast group as a (*, g). When a static IGMP group is added, multicast
data for that (*,g) is forwarded to the specific SAP without receiving any membership report from a
host.
Default none
Parameters grp-address — Specifies an IGMP multicast group address that receives data on an interface. The IP
address must be unique for each static group.
group-policy
Syntax group-policy policy-name
no group-policy
Context config>service>vpls>igmp-snooping>mvr
Description
This command identifies filter policy of multicast groups to be applied to this VPLS entity. The
sources of the multicast traffic must be a member of the VPLS.
The no form of the command removes the policy association from the VPLS configuration.
Default No group policy is specified.
Parameters
policy-name — The group policy name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes. Routing policies are configured in the
config>router>policy-options context. The router policy must be defined before it can be imported.
igmp-snooping
Syntax igmp-snooping
Context config>service>vpls
config>service>vpls>sap
config>service>vpls>spoke-sdp
config>service>vpls>mesh-sdp
config>service>pw-template
Description This command enables the Internet Group Management Protocol (IGMP) snooping context.
To Next Page
Loading...
