Show, Clear, Debug Commands
Page 424 7210 SAS-X, R6 OS Services Guide
Metric
Displays the metric to be used within the Tunnel Table Manager for deci-
sion making purposes. When multiple SDPs going to the same destination
exist, this value is used as a tie-breaker by Tunnel Table Manager users like
MP-BGP to select route with lower value.
Acct. Pol
Displays the policy to use to collect accounting statistics on this SDP. The
value zero indicates that the agent should use the default accounting policy,
if one exists.
Collect Stats
Specifies whether the agent collects accounting statistics for this SDP. When
the value is true the agent collects accounting statistics on this SDP.
VLAN VC Etype
Displays the VLAN VC type.
BW Booking Factor
Specifies the value used to calculate the max SDP available bandwidth. The
value specifies the percentage of the SDP max available bandwidth for VLL
call admission. When the value of is set to zero (0), no new VLL spoke-sdp
bindings with non-zero bandwidth are permitted with this SDP. Overbook-
ing, >100% is allowed.
PBB Etype
Displays the Ethertype used in frames sent out on this SDP when specfied as
vlan for Provider Backbone Bridging frames.
Oper Max BW (Kbps)
Indicates the operational bandwidth in kilo-bits per seconds (Kbps) avail-
able for this SDP. The value is determined by the sum of the bandwidth of
all the RSVP LSPs used by the SDP.
Avail BW (Kbps)
Indicates the bandwidth that is still free for booking by the SDP bindings on
the SDP.
Net-Domain
Specifies the network-domain name configured on this SDP. The default
value of this object is the default'network-domain.
Egr Interface
Indicates whether all the egress network interfaces that can carry traffic on
this SDP are associated with the network-domain configured on this SDP.
Not applicable: Indicates that there is no egress network interface that can
carry traffic on this SDP.
Consistent: Indicates that the network-domains for all the egress network
interfaces that can carry traffic on this SDP are consistent.
Inconsistent: Indicates that the network-domain for one or more egress net-
work interfaces that can carry traffic on this SDP are inconsistent.
Mixed LSP Mode
Indicates if the SDP is enabled to use mixed-mode-lsp.
Active LSP Type
Displays the LSP type that is currently active and in use to transport service
packets. When multiple LSPs are configured under the SDP and enabled
with the command 'mixed-mode-lsp', the active LSP could be one of the con-
figured ones. It displays RSVP, if the LSP in use is of type RSVP LSP, LDP
if the LSP in use is of type LDP LSP and BGP 3107, if LSP if of type RFC
3107 BGP Labelled route LSP.
Label Description (Continued)
To Next Page
Loading...
