Show, Clear, Debug Commands
Page 426 7210 SAS-X, R6 OS Services Guide
SDP Id : 1 SDP Source : manual
Admin Path MTU : 0 Oper Path MTU : 0
Far End : 0.0.0.0 Delivery : MPLS
Tunnel Far End : n/a LSP Types : None
Admin State : Down Oper State : Down
Signaling : TLDP Metric : 0
Acct. Pol : None Collect Stats : Disabled
Last Status Change : 11/04/2099 22:56:41 Adv. MTU Over. : No
Last Mgmt Change : 11/10/2099 15:56:44 VLAN VC Etype : 0x8100
Bw BookingFactor : 100 PBB Etype : 0x88e7
Oper Max BW(Kbps) : 0 Avail BW(Kbps) : 0
Net-Domain : default Egr Interfaces : n/a
Flags : SdpAdminDown NoSysIPAddr
TranspTunnDown
Mixed LSP Mode Information :
Mixed LSP Mode : Enabled Active LSP Type : RSVP....also be LDP, BGP
Revert Time : 200 Revert Count Down : n/a
KeepAlive Information :
Admin State : Disabled Oper State : Disabled
Hello Time : 10 Hello Msg Len : 0
Hello Timeout : 5 Unmatched Replies : 0
Max Drop Count : 3 Hold Down Time : 10
Tx Hello Msgs : 0 Rx Hello Msgs : 0
-------------------------------------------------------------------------------
RSVP/Static LSPs
-------------------------------------------------------------------------------
Associated LSP List :
No LSPs Associated
===============================================================================
*7210SAS>show>service#
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description This command displays services using SDP or far-end address options.
Parameters sdp-id — Displays only services bound to the specified SDP ID.
Values 1 — 17407
vc-id — The virtual circuit identifier.
Values 1 — 4294967295
far-end ip-address — Displays only services matching with the specified far-end IP address.
Default Services with any far-end IP address.
Output Show Service SDP Using X — The following table describes show service sdp-using output fields.
To Next Page
Loading...
