Service Commands
7210 SAS-X, R6 OS Services Guide Page 433
Sample Output
A:dut-b# show eth-cfm association
======================================================================
CFM Association Table
======================================================================
Md-index Ma-index Name CCM-interval Bridge-id
----------------------------------------------------------------------
1 1 a1 1 1
1 2 a2 1 2
2 1 a1 1 2
2 2 a2 1 1
======================================================================
A:dut-b#
cfm-stack-table
Syntax cfm-stack-table [{all-ports}] [level <0..7>] [direction <down>]
cfm-stack-table port <port-id> [vlan <qtag[.qtag]>] [level <0..7>] [direction <down>]
cfm-stack-table facility [{all-ports|all-lags|all-lag-ports|all-tunnel-meps|all-router-
interfaces}] [level <0..7>] [direction <down>]
cfm-stack-table facility lag <id> [tunnel <1..4094>] [level <0..7>] [direction <down>]
cfm-stack-table facility port <id> [level <0..7>] [direction <down>]
cfm-stack-table facility router-interface <ip-int-name> [level <0..7>] [direction <down>]
Context show>eth-cfm
Description This command displays stack-table information. This stack-table is used to display the various management
points MEPs and MIPs that are configured on the system. These can be Service based or facility based. The
various option allow the operator to be specific. If no parameters are include then the entire stack-table will
be displayed.
Parameters port port-id — Displays the bridge port or aggregated port on which MEPs or MHFs are configured.
vlan vlan-id — Displays the associated VLAN ID.
level — Display the MD level of the maintenance point.
Values 0 — 7
Bridge-id
Displays the bridge-identifier value for the domain association.
MHF Creation
Displays the MIP half function (MHF) for the association.
Primary VLAN
Displays the primary bridge-identifier VLAN ID.
Num Vids
Displays the number of VIDs associated with the VLAN.
Remote Mep Id
Displays the remote maintenance association end point (MEP) identifier
Label Description