Alcatel-Lucent 7210 SAS-X - Page 532

Show, Clear, Debug Commands
Page 532 7210 SAS-X, R6 OS Services Guide
Sample Output
*A:DUT-B_sasx>show>service>id# sap 1/1/3:63 detail
===============================================================================
Service Access Points(SAP)
===============================================================================
Service Id : 63
SAP : 1/1/3:63 Encap : q-tag
Description : (Not Specified)
Admin State : Up Oper State : Up
Flags : None
Last Status Change : 05/20/2000 13:33:22
Last Mgmt Change : 05/19/2000 12:13:41
Loopback Mode : Internal No-svc-port used : 1/1/13
Loopback Src Addr : 00:00:00:22:22:22
Loopback Dst Addr : 00:00:00:11:11:11
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
Max Nbr of MAC Addr: No Limit Total MAC Addr : 59
Learned MAC Addr : 59 Static MAC Addr : 0
Admin MTU : 1518 Oper MTU : 1518
Ingr IP Fltr-Id : n/a Egr IP Fltr-Id : n/a
Ingr Mac Fltr-Id : n/a Egr Mac Fltr-Id : n/a
tod-suite : None
Egr Agg Rate Limit : 100000 Host Conn Verify : Enabled
Mac Learning : Enabled Discard Unkwn Srce: Disabled
Mac Aging : Enabled Mac Pinning : Disabled
BPDU Translation : Disabled
L2PT Termination : Disabled
Acct. Pol : None Collect Stats : Disabled
Aggregate Policer
rate-indicates the rate of the aggregate policer.
burst-indicates the burst-size of the aggregate policer.
Loopback Mode
Displays the Ethernet port loopback mode
Loopback Src Addr
Displays the configured loopback source address
Loopback Dst Addr
Displays the configured loopback destination address
No-svc-port used
Displays the port ID of the port on which no service is configured.
This port is used for the port loop back with MAC swap functionality.
Egr Agg Rate Limit
Displays the egress aggregate rate limit
Loopback Mode
Displays the Ethernet port loopback mode
Loopback Src Addr
Displays the configured loopback source address
Loopback Dst Addr
Displays the configured loopback destination address
No-svc-port used
Displays the port ID of the port on which no service is configured.
This port is used for the port loop back with MAC swap functionality.
Label Description (Continued)