Alcatel-Lucent 7210 SAS-X - Page 566

Show, Clear, Debug Commands
Page 566 7210 SAS-X, R6 OS Services Guide
spoke-sdp
Syntax spoke-sdp sdp-id[:vc-id] {all | counters | stp| l2pt}
Context clear>service>statistics>id
Description This command clears statistics for the spoke SDP bound to the service.
Parameters sdp-id — The spoke SDP ID for which to clear statistics.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be reset.
Values 1 — 4294967295
all — Clears all queue statistics and STP statistics associated with the SDP.
counters — Clears all queue statistics associated with the SDP.
stp — Clears all STP statistics associated with the SDP.
l2pt — Clears all L2PT statistics associated with the SDP.
stp
Syntax stp
Context clear>service>statistics>id
Description Clears all spanning tree statistics for the service ID.
detected-protocols
Syntax detected-protocols {all | sap sap-id}
Context clear>service>id>stp
Description RSTP automatically falls back to STP mode when it receives an STP BPDU. The clear detected-
protocols command forces the system to revert to the default RSTP mode on the SAP.
Parameters all — Clears all detected protocol statistics.
sap-id — Clears the specified lease state SAP information. See Common CLI Command Descriptions
on page 925 for command syntax.
igmp-snooping
Syntax igmp-snooping
Context clear>service>id
Description This command enables the context to clear IGMP snooping data.