Alcatel-Lucent 7210 SAS-X - Page 622

Show Commands
Page 622 7210 SAS-X, R6 OS Services Guide
PBB Clear Commands
id
Syntax id service-id
Context clear>service
clear>service>statistics
Description This command clears commands for a specific service.
Parameters service-id — The ID that uniquely identifies a service.
Values service-id: 1 — 214748364
statistics
Syntax statistics
Context clear>service>stats
Description This command clears session statistics for this service.
fdb
Syntax fdb {all | mac ieee-address | sap sap-id] }
Context clear>service>id
Description This command clears FDB entries for the service.
Parameters all — Clears all FDB entries.
mac ieee-address — Clears only FDB entries in the FDB table with the specified 48-bit MAC
address. The MAC address can be expressed in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
sap-id — Specifies the physical port identifier portion of the SAP definition.
sap
Syntax sap service-id
Context clear>service>statistics
Description This command clears statistics for the SAP bound to the service.
Parameters sap-id — See Common CLI Command Descriptions on page XXX for command syntax.