IES Service Configuration Commands
Page 673
Description This command enables the context to apply ingress policies
counter-mode
Syntax counter-mode {in-out-profile-count|forward-drop-count}
Context config>service>ies>sap>statistics>ingress
Description This command sets the mode of ingress counters associated with the SAP to either octets or packets.
On IES SAPs, collect stats cannot be enabled so the mode of the counter can be changed without any
reference. Changing the mode of the counter results in loss of previously collected counts and resets
the counter. The no form of this command is not supported.
Default in-out-profile-count
Parameters in-out-profile-count — If the counter mode is specified as "in-out-profile-count", one counter counts
the total in-profile packets and octets received on ingress of a SAP and another counts the total
out-of-profile packets and octets received on ingress of a SAP. A packet is determined to be in-
profile or out-of-profile based on the meter rate parameters configured. A packet is dropped by
the policer if it exceeds the configured PIR rate. Dropped counts are not maintained in hardware
when this mode is used. It is obtained by subtracting the sum of in-profile count and out-of-
profile count from the total SAP ingress received count and displayed.
forward-drop-count — If the counter mode is specified as "forward-drop-count", one counter
counts the forwarded packets and octets received on ingress of a SAP and another counts the
dropped packets. The forwarded count is the sum of in-profile and out-of-profile packets/octets
received on SAP ingress. The dropped count is count of packets/octets dropped by the policer. A
packet is determined to be in-profile or out-of-profile based on the meter rate parameters
configured. A packet is dropped by the policer if it exceeds the configured PIR rate. The in-
profile count and out-of-profile count is not individually available when operating in this mode.
tod-suite
Syntax tod-suite tod-suite-name
no tod-suite
Context config>service>ies>if>sap
Description This command applies a time-based policy (filter or QoS policy) to the service SAP. The suite name
must already exist in the config>cron context.
Default no tod-suite
Parameters tod-suite-name — Specifies collection of policies (ACLs, QoS) including time-ranges that define the
full or partial behavior of a SAP. The suite can be applied to more than one SAP.
To Next Page
Loading...
